Wireless remote control range
Vertically
Alignment marks
2. To remove the battery pack: |
Push up on the button from the front to re |
|
|
|
|
| ° | |
|
|
|
| 0 | ||
|
|
| 6 |
|
| |
|
| . |
|
|
| |
|
| x |
|
|
|
|
|
| o |
|
|
|
|
|
| r |
|
|
|
|
| p |
|
|
|
| |
A | p |
|
|
|
|
|
|
|
|
|
|
| |
Approx. |
|
| ||||
|
|
|
| 50 | cm | |
|
|
|
|
|
| |
Approx.6 0 °
lease the battery pack. |
Button
V. OPERATION
Before Using the Remote Control (Available as an optional accessory)
Insert the battery
1.Pull out the battery holder.
1Push in on the fas- tener as indicated by the arrow.
2 Pull out the holder.
The remote control should be operated within approximately 50 cm and approximately 60° vertically and horizontally of the perpendicular relative to the infrared receiver on the tool.
•Under the following circumstances, you may not be able to operate the tool, even within this range.
•If there is an object between the remote control’s transmitter and the tool’s receiver.
•Use outdoors or in other environments where the remote control receiver is exposed to a strong light source, or when the remote control transmitter or receiv- er is dirty may cause the tool to fail to respond, even when the remote control is used within the operating range.
[Main Body]
Switch and Forward/Reverse
Lever Operation
2.Insert the battery and push the holder
back in.
NOTE:
•If the tool does not respond to the wire- less remote control even when the remote control is operated close to the tool, the battery (CR2025) is dead. Replace it with a fresh battery.
•The included battery is provided for sample use and may not last as long as commer- cially available batteries.
ForwardReverse
Switch lock
CAUTION:
To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop.
- -
