Multiquip MVC80VH/VHW manual Startup, Place the Engine ON/OFF switch in the on position

STARTUP

CAUTION

DO NOT attempt to run the compactor until the Safety and Initial Start-up sections have been read and understood.

1. Place the fuel valve lever (Figure 9) in the "ON" position.

Figure 9. Fuel Valve Lever

2.Place the Engine ON/OFF switch (Figure 10) in the "ON" position.

Figure 10. Engine ON/Off Switch

3. Place the Choke Lever(Figure 11) in the "OPEN" position.

Figure 11. Choke Lever

NOTICE

The CLOSED position of the choke lever enriches the fuel mixture for starting a COLD engine. The OPEN position provides the correct fuel mixture for normal operation after starting, and for restarting a warm engine.

4.Place the throttle lever (Figure 12) halfway between fast and slow.

Figure 12. Throttle Lever

5.Grasp the starter grip (Figure 13) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingthecompressionpoint.Rewindtheropealittlefrom that point and pull out sharply.

CAUTION

DO NOT pull the starter rope all the way to the end

DO NOT release the starter rope after pulling. Allow it to rewind as soon as possible.

Figure 13. Starter Grip

PAGE 18 — MVC80VH/VHW PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #3 (1/13/11)