MAINTENANCE

CAUTION

Make sure hydraulic oil is at a normal safe operating level. DO NOT over fill. Over filling (excessive oil) will cause excess oil to blow out of breather plug.

3.Loosen bleeder plug located at top of hydraulic cylinder on side of vibrator (Figure 32). Air remaining in the circuit will be forced out of the bleeder plug. Once all air has been purged from the hydraulic system, tighten bleeder plug securely

4.Re-insert oil plug into hydraulic oil tank and tighten securely. Re-install breather cap.

NOTICE

The bleeder plug should only be loosened, but not removed.

Figure 32. Bleeder Plug

BATTERY MAINTENANCE (Option)

Mishandling of the battery shortens the service life of the battery and adds to maintenance cost. When handling the battery do the following:

CAUTION

Wear safety glasses or face mask, protective clothes, and rubber gloves when working with battery.

The battery electrolyte contains sulphuric acid, be careful not to let the battery electrolyte come in contact with your body or clothing.

Always check the battery terminals periodically to ensure that they are in good condition.

Always wear eye protection and rubber gloves, since the battery contains sulfuric acid which burns skin and eats through clothing. In case of contact, flush thoroughly with water and contact a doctor immediately.

Use wire brush or sand paper to clean the battery terminals.

Always check battery for cracks or any other damage. If white pattern appears inside the battery or paste has accumulated at the bottom, replace the battery.

If the compactor will not be in operation for a long period of time, store in cool dry place and check the battery charge level every month to maintain the performance of the battery.

Check the battery regularly and make sure that each electrolyte level is to the bottom of the vent well (Figure 33). If necessary add only distilled water in a well- ventilated area.

Figure 33. Battery Electrolyte Levels

BATTERY CHARGING

DO NOT charge battery with the battery cables connected to the compactor. The diodes will be damage by the high voltage.

Batteries generate hydrogen gas which can be highly explosive. DO NOT smoke or allow flames or sparks near the battery, especially during charging of the battery.

Charge the battery in a open air environment (plenty of ventilation).

Before charging , remove the cap from each cell of the battery.

Connect the positive (+) lead of the charger to the positive

(+) terminal of the battery and the negative (-) lead of the charger to the negative (-) terminal of the battery. DO NOT reverse the polarity when charging. Reverse polarity will damage the charger rectifer or the battery.

PAGE 24 — MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14)

Page 24
Image 24
Multiquip MVH-306DS manual Bleeder Plug Battery Maintenance Option, Battery Charging