Multiquip MVH-402GHB manual Adjusting Handle Height, Throttle Lever Start

CAUTION :

DO NOT attempt to operate the compactor until the

Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.

MVH-402GHB — OPERATION

2.Move the throttle lever to the START position by opening it to about 20 degrees (Figure 9).

This section is intended to assist the operator with the initial start-upof the compactor. It is extremely important that this section be read carefully before attempting to use the compactor in the field.

Refer to Figures 3 and 4 for the location of controls and components.

Adjusting Handle Height

The height of the handle is adjustable for your comfort .

1.Loosen the butterfly screw (Figure 7).

2.Turn the grip clockwise to raise the handle or counterclock- wise to lower the handle.

3.When the handle is raised to the desired height, tighten the butterflyscrew.

Figure 9. Throttle Lever (Start)

3.Place the choke lever (Figure 10) in the CLOSED position if starting a cold engine.

Figure 10. Engine Choke Lever (Open)

4.Place the choke lever (Figure 11) in the OPEN position if starting a warm engine or the temperature is warm.

Figure 7. Handle Adjustment

Starting the Engine

Recoil Start

1.1. Place the engine fuel valve lever to the "ON" position. (Figure 8).

Figure 11. Engine Choke Lever (Closed)

Figure 8. Fuel Valve Lever

MQ-MIKASA MVH-402GHB PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (12/17/03) — PAGE 17