Multiquip S-500SERIES SUB. PUMP - SPECIFICATIONS, Control Box Specifications, VoltageType

S-500 SERIES SUB. PUMP — SPECIFICATIONS

TABLE 1. SPECIFICATIONS

Model	S-500P		S-500UL
Type	Centrifugal		Centrifugal
	Submersible Pump		Submersible Pump
Impeller	Rubber		Rubber
Suction & Discharge Size	2.00 in. (51 mm)		1.50 in. (38 mm)
Maximum Pumping Capacity	61 gallons/minute		63 gallons/minute
	(230 liters/minute)		(238 liters/minute)
Max. Solids Diameter	N/A		N/A
Max Head	34 ft. (10.4 meters)		36 ft (11.0 meters)
Power	0.5 HP (0.37kw)		0.5 HP (0.37kw)
Voltage Phase	1Ø 115V		1Ø 115V
Starting Amps	50.4		44.1
Running Amps	7.2		6.3
Control Box Required	NO (Note 3)		NO (Note 3)
Thermal Overload Protection	YES		YES
Rotation	CCW (Note 1)		CCW (Note 1)
Mechanical Oil seal Capacity	180 cc. (Note 2)		150 cc. (Note 2)
Check Frequency	Monthly (300 hrs.)		Monthly (300 hrs.)
RMP (Speed)	3550 +/- 30		3550 +/- 30
Power Cable Length	25 FT.	(7.6 cm.)	25 FT. (7.6 cm.)
Dry Net weight	22 lbs.	(10 Kg.)	21 lbs. ( 9.5 Kg.)

1.Motor Rotation – Upon start-up, the pump "kicks" in the opposite direction of motor rotation. The correct rotation is counterclockwise (CCW) as viewed from the impeller end of the pump.

2.Mechanical Oil Seal – Use a good grade 10 weight non-detergent hydraulic oil (i.e. Shell Turbo 32 or equivalent).Fill oil cavity 75% to 85% full (allow air space for expansion).

3.Control Box - Control box (Table 2) may be required for certain pumping applications.

Table 2. Control Box Specifications

Model No.	VoltageType	UL/CSA	Thermal	Float
			Overload	Switch
		Listed
			Protection	Capability
CB3	115 VAC, 60 Hz Single-	YES	NO	YES
	Phase

S-500 SERIES SUBMERSIBLE PUMPS — OPERATION & PARTS MANUAL — REV. #0 (10/01/04) — PAGE 9