camlok/voltage output panel
3
1 | 2 |
4 5
7
8
GREEN WHITE RED BLUE BLACK
6
7
8
9
Figure 7. Camlok/Voltage Output Panel
The definitions below describe the controls and functions of the Camlok/Voltage Output Panel (Figure 7).
1.CB4/CB5 Circuit Breakers — These circuit breakers protect the 120 VAC auxiliary output receptacles from overload.
2.CB6/CB7 Circuit Breakers — These circuit breakers protect the bates output receptacles from overload.
3.Generator Voltage Test Points — To determine if the generator's output voltage is present and correct, connect a test meter to these test points during troubleshooting and maintenance.
4.Paralleling Cable In — This Ethernet input connection point is used when multiple generators are going to be connected.
5.Paralleling Cable Out — This Ethernet output connection point is used when multiple generators are going to be connected.
6.BUS Hot Indicator Lamp — When lit, this indicator lamp informs that the voltage bus is active (high voltage). NEVER connect or disconnect cables from the camlok or auxiliary receptacles when this indicator is ON. The possibility exists of electrocution, shock or even death if cables are connected or unplugged when this indicator is lamp lit.
7.120 VAC Output Receptacles — These
8.Bates 120VAC Output Receptacles — These receptacles provide AC voltage output. Each receptacle is protect by a 100 amp breaker. These receptacles cannot be used when the voltage selector switch is in the 3Ø 277/480 VAC position.
9.Camlok Receptacles — These output voltage connection points (6 pairs) are used for load connection. ALWAYS pay close attention when connecting and disconnecting power cables from these camlok receptacles. The possibility exists of electrocution, shock or even death if cables are connected or unplugged when the bus hot indicator lamp is lit.
SG1400c3 studio generator • operation manual — rev. #0 (10/05/11) — page 25
