Multiquip SG1400C3 General Inspection, Air FILTER, Air Filter Dust Indicator, Fuel Addition

Models: SG1400C3

1 62
Download 62 pages 40.87 Kb
Page 39
Image 39
General Inspection

maintenance

General Inspection

Prior to each use, the generator should be cleaned and inspected for deficiencies. Check for loose, missing or damaged nuts, bolts, and other fasteners. Also check for fuel, oil, and coolant leaks. Use Table 14 as a general maintenance guideline. For engine maintenance, refer to the engine maintenance manual.

Air FILTER

Every 250 hours: Remove air filter element (Figure 33) and clean the filter element with low pressure compressed air. Air pressure must not exceed 30 psi (207 kPa). The filter can be cleaned and reused for up to six times if properly cleaned. Replace air filter if rips or tears are detected while cleaning.

Air Filter Dust Indicator

The air filter indicator (Figure 33) is attached to the air filter. When the air filter element is clogged, air intake restriction becomes greater and the air filter indicator signal shows RED. When indicator is red, replace filter immediately. After changing the air filter, press the air filter indicator button to reset.Air FILTER

Air Filter

Air Filter Dust IndicatorFigure 33. Air Filter/IndicatorFuel AdditionRemoving Water from the Fuel Tank Indicator

Air Filter

Element

Figure 33. Air Filter/Indicator

Cleaning Inside the Fuel TankNOTICE

The air filter should be changed more frequently in dusty operating conditions.

If the engine is operating in very dusty or dry grass conditions, a clogged air cleaner will result.This can lead to a loss of power, excessive carbon buildup in the combustion chamber and high fuel consumption. Change air cleaner more frequently if these conditions exist.

Fuel Addition

Add diesel fuel (the grade may vary according to season and locations).

Removing Water from the Fuel Tank

After prolonged use, water and other impurities accumulate in the bottom of the tank. Occasionally inspect the fuel tank for water contamination and drain the contents if necessary.

During cold weather, the more empty volume inside the tank, the easier it is for water to condense. This can be reduced by keeping the tank full with diesel fuel.

Cleaning Inside the Fuel Tank

If necessary, drain the fuel inside the fuel tank completely. Using a spray washer (Figure 34) wash out any deposits or debris that have accumulated inside the fuel tank.

Figure 34. Fuel Tank Cleaning

SG1400c3 studio generator • operation manual — rev. #0 (10/05/11) — page 39

Page 39
Image 39
Multiquip SG1400C3 General Inspection, Air FILTER, Air Filter Dust Indicator, Fuel Addition, Cleaning Inside the Fuel Tank