Multiquip SP2S13H20A Traveling During Cutting, Place the travel lever in the Neutral position

OPERATION

CAUTION

DO NOT force the blade into the cut any faster than its designed tendency is effective cut and remove material. This can damage your blade and/or your machine.

3.Move the travel lever towards the FORWARD position to increase forward travel speed during cutting (Figure 40). Placing the travel lever fully forward will move the saw at maximum speed.

Traveling During Cutting

The SP2S13H20A saw has a hydrostatic transmission which mechanically propels the saw during cutting operations. To prepare the machine for self-propelled cutting:

1. Place the travel lever in the NEUTRAL position.

Figure 40.Transmission Engage/Disengage Lever

(Forward Position)

4.When reverse movement is required, move the travel lever towards the REVERSE position (Figure 41). Placing the travel lever fully in reverse will move the saw backwards at its maximum reverse speed.

Figure 38.Transmission Engage/Disengage Lever

(Neutral Position)

2.Lift the transmission engage/disengage lever, located on the console (Figure 39). Leaving the lever down disengages the transmission to allow for manual pushing during cutting or moving the machine around the job site.

Figure 39.Transmission Engage/Disengage Lever

(Engage Position)

Figure 41.Transmission Engage/Disengage Lever

(Reverse Position)

Saw Alignment

1.The SP2S13H20A saw employs a front pointer (Figure 42) that has been precisely aligned with the diamond blade at the factory. Referencing the figure below, accurate tracking is accomplished by referencing the front pointer tip over the cut line. Precise saw direction is accomplished by slight operator pressure against the handle bars.

Figure 42. Saw Pointer

2.To reorient a pointer position, loosen the screw that secures the pointer bar to the shaft, adjust as necessary, and retighten the screw.

SP2S13H20A SAW — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10) — PAGE 29