Multiquip SP2S13H20A General Transmission Care, Transmission Reservoir Cup, Spline GearWheels

MAINTENANCE

General Transmission Care

All SP2S13H20A model saws utilize spline gear wheel design coupled with an EATON Model 7 Hydrostatic Transmission that provides forward/reverse propulsion. The simple design of the system keeps maintenance to a minimum.

Transmission Reservoir Cup:

Check every 8 hours of operation. When the transmission is cold (A), check oil level against the level indicator (see Figure 45).

CAUTION

DO NOT use multiple viscosity oils! DO NOT OVERFILL.

Spline GearWheels:

Check every 25 hours and clean as necessary. If the spline wheels DO NOT engage the rear wheels with sufficient pressure, slippage of the rear wheels may occur.

To adjust the Spline Gear Assembly:

1.Place the transmission engage/disengage lever in the DISENGAGE position (Figure 46) .

Figure 45. Transmission Reservoir

Servicing:

Thetransmissionreservoiris factoryfilled.Shouldservicing berequired,useSAE20W-20,APIclassification(SE,CC,CD) or better, General Motors Dexron B, Ford M2C-33F, M2C- 41A or International Harvester Hy-Tran fluids. For extreme hot weather, drain oil and refill with an oil having a viscosity of SAE30W-30 or SAE40W-40.

Drive Chain:

Checkevery50hours. Periodicallywipethechaincleanand re-lubricate with penetrating chain oil.

The drive chain may stretch requiring tension adjustments. To adjust the drive chain tension:

1.Loosenthe(3)transmissionattachmentscrews(Hydrostatic. Transmission Assy., item 2)

2.Pivot the transmission in the“U”slots of the transmission mount until the proper tension is achieved (Hydrostatic Transmission Assy., item 7).

NOTE

Excessivetensiononthedrivechain will reduce chain life.

Figure 46. Transmission Engage/Disengage Lever

(Disengage Position)

3.Loosenthelinkageadjustmentnutandslightlylengthenthe linkagerod(seeTransmissionEngageLeverAssy.,items11 and 13).

4.Move the transmission engage/disengage lever to the ENGAGEpositiontoobservetheproperspline-to-rearwheel contact.

5.Retighten the adjustment nut.

SP2S13H20A SAW — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10) — PAGE 33