Multiquip SP2S13H20A manual General Safety, Diamond Blade Safety

RULES FOR SAFE OPERATION

General Safety

ALWAYS read, understand, and follow procedures in Operator's Manual before attempting to operate equipment.

ALWAYS be sure the operator is familiar with proper safety precautions and operating techniques before using the saw.

NEVER leave the machine unattended while running.

Block the unit when leaving or when using on a slope.

ALWAYS check to make sure that the operating area is clear before starting the engine.

Maintain this equipment in a safe operating condition at all times.

ALWAYS stop the engine before servicing, adding fuel and oil.

NEVER run the engine without the air filter. Severe engine damage could occur.

ALWAYS service air cleaner frequently to prevent carburetor malfunction.

AVOID wearing jewelry or loose fitting clothing that may snag on the controls or moving parts, this can cause a serious injury.

ALWAYS keep clear of rotating or moving parts while the saw is in operation.

ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.

NEVER use accessories or attachments which are not recommended by the manufacturer for this equipment. Damage to the equipment and/or injury to user may result.

Keep all inexperienced and unauthorized people away from the equipment at all times.

WARNING

ALWAYS check to make sure that the operating area is clear before starting the engine.

Diamond Blade Safety

Use appropriate steel centered diamond blades manufactured for use on saws.

Examine blade flanges for damage, excessive wear and cleanliness before mounting blade. Blade should fit snugly on the shaft and against the inside/outside blade flanges.

Ensure the blade is marked with an operating speed greater than the blade shaft speed of the saw.

WARNING

ALWAYS inspect diamond blades before each use. The blade should exhibit no cracks, dings, or flaws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.

Only cut the material that is specified by the diamond blade. Read the specifications of the diamond blade to ensure the proper tool has been matched to the material being cut.

ALWAYS keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees.

Ensure that the diamond blade does not come into contact with the ground or surface during transportation. DO NOT drop the diamond blade on ground or surface.

The engine governor is designed to permit maximum engine speed in a no-load condition. Speeds that exceed this limit may cause the diamond blade to exceed the maximum safe allowable speed.

Ensure that the blade is mounted for proper operating direction.

SP2S13H20A SAW — OPERATION AND PARTS MANUAL — REV. #1 (05/17/10) — PAGE 11