ST-3050D SUBMERSIBLE PUMP — OPERATION
4.NEVER!grabortouchalivepowercord (Figure18)withwet hands, the possibility exists of electricalshock, electrocu- tion and even death.
WET
HANDS
POWER
CORD
(POWER ON)
Figure 18. Power Cord (Wet Hands)
DANGER:
NEVER! grab or touch a live power cord. DO NOT stand in water when connecting the pump's power cord into a voltage source.The possibility exist of electrical shock, electrocution and possibly death!
3.If all of the pump's electrical requirements have been met, insert the power plug on the pump into the power source receptacle.
4.Wait a few seconds and water should begin to flow from the discharge hose.
5.If water is not flowing from the discharge hose or not flowing freely after a few minutes, remove the power from the pump and check the system for leaks.
Pump Shut-Down/Clean-up
1.Remove the power from the pump by turning off the circuit breaker or switch that provides power to the pump. Remem- bertomakesurethathandsaredry(notwet),andfeetarenot standing in water when removing disconnecting power from thepump.
2.Usingtheliftingrope,liftthepumpupfromitscurrentposition. Remove the discharge hose from the discharge port on the pump.
3.Remove all power cables and float switches from the control box. Place cables and float switches in a suitable container where they will not get damaged.
4.Ifthepumpwasusedtopumpmud,gritorsilt,flush vigorously with clean water.
5.Removethepumpfromthewater.Wipeoffanymudordebris that might have attached itself to the pump.
6.Store pump in a clean dry place away from dirt and debris.
