ST2037, 47, 47B, 38P, 40T SUB. PUMP — FLOAT SWITCH (PIGGY-BACK)
Float Switch
Single or dual control float switches (Figure 6) can be used for the unattended operation of the submersible pump. When using the
Mounting The Float Switch |
| Figure 6 shows a single float switch | ||
1. | Determine the required cord tether length as shown in | NOTE | ||
application. For dual float switch | ||||
| Figure 6 and Table 3. | |||
|
| capability use a Model | ||
2. | Place the cord into the clamp as shown in Figure 6. |
| ||
| type float switch . | |||
|
|
|
3.Secure the clamp to the discharge hose as shown in Figure 5. DO NOT install cord under hose clamp.
4.Using a screwdriver, tighten the hose clamp.DO NOT over- tighten. Make sure the float cord is not allowed to touch the excess hose clamp band during operation.
Figure 6. Single Float Switch
Application Diagram
ST2037,47, 47B, 38P, 40T SUB. PUMPS — OPERATION AND PARTS MANUAL — REV. #3 (06/15/10) — PAGE 13