RedMax GZ400 manual Operation, F8-1 F8-2 F8-3, F8-4, F8-5, English

English

F8-1

F8-2

F8-3

(4)

8. Operation

WARNING

It is very dangerous to run a chain saw that mounts broken parts or lacks any parts.

Before starting engine, make sure that all the parts including bar and chain are installed properly.

■STARTING THE ENGINE

1.Fill fuel and chain oil tanks respectively, and tighten the caps securely. (F8-1)

2.Set the switch to “I” position. (F8-2)

(1)Chain oil

(2)Fuel

(3)Switch

3.Continuously push the primer until fuel comes in the bulb. (F8-3)

(4) Primer

4.Pull the choke knob all the way out to FULL CHOKE position. (F8-4)

(5) Choke knob (FULL CHOKE Position)

(a) RUN (b) HALF CHOKE (c) FULL CHOKE

F8-4
(a)	(5)
(b)
(c)
F8-5

5.While holding the saw unit securely on the ground, pull the starter grip until the engine attempts to start, but no more than 5 times. (F8-5)

WARNING

Do not start the engine while the chain saw hangs in one hand. The saw chain may touch your body. This in very dangerous.

6.Push the choke knob to HALF CHOKE position.

7.Pull starter grip until engine runs.

NOTE

Allow the saw to run in this position 15~30 seconds, depending upon the temperature.

28