RedMax GZ400 Symbols on the machine, Important Emissions Information, engine is warm, English

English

4. Symbols on the machine

	For safe operation and maintenance,
	symbols are carved in relief on the
	machine.
	According to these indications, please
	be careful not to make any mistake.
(a)	(a) The port to refuel “MIX GASOLINE”
	Position: Fuel cap
	(b) The port to top up chain oil
(b)
	Position: Oil cap
(c)	(c) By setting the switch to the “O” position, the engine
	stops immediately.
	Position: Rear-left of the unit
	(d) If you pull out the choke knob (at the back-right of
	the rear handle) to the point of the arrow, you can
(d)	set the starting mode as follows:
	• HALF CHOKE position – starting mode when the
	engine is warm.
	• FULL CHOKE position – starting mode when the
	engine is cold.
	Position: Upper-right of the aircleaner cover

(e)	(e) The screw under the “H” stamp is the High-speed
	adjustment screw.
	The screw under the “L” stamp is the Slow-speed
	adjustment screw.
	The screw at the left of the “T” stamp is the Idle
	adjustment screw.
	Position: Left side of the rear handle
	(f) Shows the directions that the chain brake is
(f)
	released (white arrow) and activated (black arrow).
	Position: Front of the chain cover
	■ EMISSION CONTROL
	An emission control label is located on the engine.
	IMPORTANT EMISSIONS INFORMATION
	THIS ENGINE MEETS U.S. EPA PH2 AND
	2007*1 CALIFORNIA EXH AND EVP
	EMISSION REGULATIONS FOR SI SORE’s.
	COMPLIANCE PERIOD : CATEGORY C
	ENGINE FAMILY : 7HCPS.0404AA ; EM*2
	ENGINE DISPLACEMENT : 40cc
	EMISSION CONTROL SYSTEM : EXH;EM
	REFER TO OWNER’S MANUAL FOR MAINTE-
	NANCE, SPECIFICATIONS AND ADJUSTMENTS.
	MANUFACTURED:
	ZENOAH CO.,LTD.
	USE JASO FC OR ISO EGC GRADE 50:1 OIL
	*1: The year will be changed every year of
	manufacturing.
	*2: The initial number will be changed every year of
	manufacturing.

8