Vibratory Control
1.For vibratory action, with the engine running (full speed) place the vibratory control lever ( Figure 30) to the ON position.The roller will now produce a vibratory frequency of 4,400 vps.
CAUTION :
NEVER! engage vibrator on concrete or asphalt type surfaces.
Figure 30.Vibratory Control Lever (ON)
Shut-Down
1.Place the vibration control lever (Figure 31) on the roller to the OFF position (vibration stops).
Figure 31.Vibratory Control Lever (OFF)
V304 — OPERATION
2.Place the water valve in the CLOSED position (if used).
3.Place the engine throttle lever (Figure 23) in the slow position, and let the engine idle for
4.Place the EngineON/OFFswitch(Figure 32) in the "OFF" position and remove the key. Place the key in a save place.
Figure 32. Engine Ignition Switch (OFF Position)
4.Place the engine fuel valve lever (Figure 20) in the OFF position.
5.Clean the entire roller with warm water and mild soap. Pay close attention to the scrapper bar and spray bar holes, making sure that no dirt or debris is present. Dirt and debris can cause the sprinkler system to get clogged.
PAGE 26
