Multiquip V304 manual Initial Start-up Instructions Handle Bar Adjustment, Handle Positions

Initial Start-up Instructions

Handle Bar Adjustment

Adjustment of the handle bar is made by removing the handle bar hitch pin, then pulling the release pin. Once released pin has been removed, position handle bar to desired height (Figures 17 and 18), then insert release pin and lock with cotter pin.

Figure 17. Handle Positions 1

V304 — INITIAL START-UP

Figure 18. Handle Positions 2

Starting

CAUTION:

DO NOT attempt to operate the roller until the Safety, General Information and Inspection sections have been read and understood. Depending on the type of engine installed on roller, operating steps may vary somewhat.See engine manufactures operating manual. The following start-up procedure makes reference to a HONDA engine.

1.ALWAYS make sure that the emer- gency stop button (Figure 19) is pulled all the way out (disengage).

Figure 19. Emergency Stop Button

2.Place the engine fuel valve lever (Figure 20) to the "ON" position.

Figure 20. Engine Fuel Valve Lever

V304 VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09) — PAGE 23