V304 — INITIAL START-UP
3.Place the Engine ON/OFF switch (Figure 21) in the "ON" position.
Figure 23. Throttle Lever
Figure 21. Engine Ignition Switch (0n Position)
NOTE
The CLOSED position of the choke lever enriches the fuel mixture for starting a COLD engine.The OPEN position provides the correct fuel mixture for normal operation after starting, and for restarting a warm engine.
4. Place the Choke Lever (Figure 22) in the "OPEN" position
Figure 22. Choke Lever
5.Place the throttle lever (Figure 23) halfway between fast and slow for starting. All sawing is done at full throttle. The
engine governor speed is factory set to ensure optimum blade operating speeds.
6.Place the Engine ON/OFF switch (Figure 24) to the "START" position. Hold until engine starts.
Figure 24. Engine Ignition Switch (Start Position)
NOTE
DO NOT keep the ignition switch in the START position for more than 5 seconds.
7.If the engine has started allow switch to return to ON position, then slowly return the choke lever (Figure 22) to the CLOSED position. If the engine has not started repeat steps 1 through 5.
8.Before the roller is placed into operation, run the engine for several minutes. Check for fuel leaks, and noises that would associate with a loose guard and/or covers.
9.All rolling is done at full throttle. Your engine governor has
been set at the factory to ensure an optimum speed setting.
PAGE 24
