V304 — ROLLER COMPONENTS

Figure 5. Roller Components 2

Figure 5 shows the location of additional components for the V304 compaction roller. The function of each component or control is described below:

1.Vibration Drive V-BeltThis belt is require to make the roller vibrate. Check this V-belt as outlined in the maintenance section of this manual.

2.Free Wheel Engagement Lever – Under normal conditions this lever should be place in the forward position (engaged). In the event the roller becomes disable and must be moved (will not start), place the lever in the side position (disengaged).

This will allow the roller drum to rotate (free wheel). IMPORTANT!, this lever is only to be used in cases where the roller has be disabled. In normal operating conditions this lever should be left in the engaged position (forward)

3.Travel Drive V-BeltThis belt is require to make the roller travel in a forward or reverse direction. Check this V-belt as outlined in the maintenance section of this manual.

4.Compartment Hood – Remove this hood to gain access to the V-belts, hydrostatic pump, coupling components, free wheel engagement lever etc.

5.Hydrostatic Pump – Provides hydraulic pressure to the drive system.

6.Hydrostatic Fluid Reservoir – Fill this reservoir with hydrostatic transmission fluid. Fill with Mobil 300, GM Dextron B or Ford MCZ-41A type transmission fluid.

7.Cogged- Drive Belt – This belt is used with the hydraulic pump. Check this cogged drive belt as outlined in the maintenance section of this manual.

PAGE 16 —V304 VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09)

Page 16
Image 16
Multiquip manual V304 Roller Components