MT5634ZBA-USB User Guide
Command: \Qn | Flow Control Selection |
Values: | n = 0, 1, or 3 |
Default: | 3 |
Description:\Q0 | Disable flow control (same as &K0). |
\Q1 | XON/XOFF software flow control (same as &K4). |
\Q2 | |
\Q3 | RTS/CTS hardware flow control (same as &K3). |
Command: \Tn | Inactivity Timer |
Values: | n = 0, |
Default: | 0 |
Description:\Tn | Sets the time (in minutes) after the last character is sent or received that the modem waits |
| before disconnecting. A value of zero disables the timer. Applies only in buffer mode. |
Note: You can also set the inactivity timer by changing the value of S30.
Command: \Vn | Protocol Result Code |
Values: | n = 0, 1, or 2 |
Default: | 1 |
Description:\V0 | Disable the appending of the protocol result code to the DCE speed. |
\V1 | Enable the appending of the protocol result code to the DCE speed. |
\V2 | Same as \V1. |
Command: \Xn | XON/XOFF |
Values: | n = 0 or 1 |
Defaults: | 0 |
Description:\X0 | Modem responds to and discards XON/XOFF characters. |
\X1 | Modem responds to and passes XON/XOFF characters. |
Command: | Data Calling Tone |
Values: | n = 0 or 1 |
Defaults: | 0 |
Enable V.25 data calling tone to allow remote data/fax/voice discrimination. | |
Command: %B | View Numbers in Blacklist |
Values: | n/a |
Description: | If blacklisting is in effect, AT%B displays the numbers for which the last call attempted in |
| the previous two hours failed. In countries that do not require blacklisting, the ERROR re- |
| sult code appears. |
Command: %Cn Data Compression Control | |
Values: | n = 0 or 1 |
Default: | 1 |
Description:%C0 Disable V.42bis/MNP 5 data compression. | |
%C1 Enable V.42bis/MNP 5 data compression. | |
Command: %DCnAT Command Control | |
Values: | n = 0 or 1 |
Default: | 0 |
Description: %DC0 The modem responds to AT commands. %DC1 The modem ignores AT commands.
Note: The modem will respond to AT%DC for 10 seconds after
30
