Multitech MT5634ZBA-USB User Guide Command &Tn V.54 Test Commands, Display Current Settings

MT5634ZBA-USB User Guide

Command: &Tn V.54 Test Commands

Values:	n = 0, 1, 3 or 6
Default:	None
Description:&T0	Abort. Stop any test in progress.
&T1	Local analog loopback test.
&T3	Local digital loopback test.
&T6	Remote digital loopback test.

Note: To stop a test, you must use the escape sequence (+++AT) before typing AT&T0.

Command: &V	Display Current Settings
Values:	n/a
Description:	Displays the active modem settings, including the callback security settings if callback se-
	curity is enabled. If the setup password has been entered, it also displays the callback secu-
	rity passwords.
Command: &Wn Store Current Configuration
Values:	n = 0
Default:	None

Description:&W0 Stores current modem settings in nonvolatile memory and causes them to be loaded at power-on or following the ATZ command instead of the factory defaults. See also the &F

	command.
&W1 Clears user default settings from nonvolatile memory and causes the factory defaults to be
	loaded at power-on or following the ATZ command.
Command: &Yn	Select Stored Configuration for Hard Reset
Values:	n = 0
Default:	0
Description:&Y0	Select stored configuration 0 on power-up. (For backward compatibility with some soft-
	ware.)
&Y1	Not supported—responds ERROR.
Command: &Zy=x Store Dialing Command
Values:	y = 0–1
	x = Dialing command
Default:	None
Description:	Stores dialing command x in memory location y. Dial the stored number using the com-
	mand ATDS=y.
Command: \An	Select Maximum MNP Block Size
Values:	n = 0, 1, 2, or 3
Default:	3
Description:\A0	64-character maximum.
\A1	128-character maximum.
\A2	192-character maximum.
\A3	256-character maximum.
Command: \Bn	Transmit Break
Values:	n = 0–9 in 100 ms units
Default:	3
Description:	In non-error-correction mode only, sends a break signal of the specified length to a remote
	modem. Works in conjunction with the \K command.

28