MAINTENANCE
HOW TO CHECK AND ADJUST THE DRIVE BRAKE
Completely push the brake pedal forward. Set the parking brake. Move the automatic drive disconnect to the PUSH position. Push the unit. If the rear wheels rotate, adjust or replace the brake pads. Adjust the drive brake as follows.
1.The location of the drive brake is on the right side of the gearbox (Figure 22).
2.Make sure the parking brake is set and the automatic drive disconnect is in the PUSH position. Turn the hex nut in a clockwise direction until the rear wheels do not turn when the unit is pushed forward.
3.Release the parking brake and push the unit. If the unit does not roll, turn the hex nut in a counterclockwise direction until the unit rolls.
4.Set the parking brake. Push the unit. If the rear wheels do not turn, the drive brake is correctly adjusted. Release the parking brake.
WARNING: If you cannot correctly adjust the drive brake, replace the brake pads. Correct replacement parts and assistance are available from an autho- rized service center.
Drive Brake |
|
Hex Nut | Gearbox |
| |
| Figure 22 |
MAINTENANCE FREE BATTERY
HOW TO REMOVE THE BATTERY
To charge or clean the battery, remove the battery from the unit as follows.
WARNING: To prevent sparks, disconnect the black battery cable from the negative
WARNING: The battery contains sulfuric acid which is harmful to the skin, eyes and clothing. If the acid gets on the body or clothing, wash with water.
1.Disconnect the black cable from the negative
2.Disconnect the red cable from the positive (+) terminal.
3.Lift the battery tray and the battery out of the unit.
HOW TO CLEAN THE BATTERY
1.Remove the battery.
2.Wash the battery with a solution of one gallon of water and four tablespoons of baking soda (sodium bicarbonate). Make sure the solution does not get into the battery cells.
3.Clean the terminals and the ends of the cables with a wire brush.
4.Install the battery.
5.To prevent corrosion, apply grease to the battery terminals.
HOW TO CHARGE THE BATTERY
WARNING: When you charge the battery, do not smoke. Keep the battery away from any sparks. The fumes from the battery acid can cause an explosion.
1.Before you charge the battery, remove the battery.
2.To charge the battery, use a 12 volt battery charger. Charge at a rate of 6 amperes for 1 hour.
3.Install the battery.
WARNING: To prevent sparks, fasten the red cable to the positive (+) terminal before you connect the black cable.
4.Fasten the red cable to the positive (+) terminal with the fas- teners as shown.
5.Fasten the black cable to the negative
| Positive (+) |
|
| Terminal |
|
Wing Nut |
| Red Cable |
|
| Carriage Bolt |
|
| Battery |
Black Cable |
| Battery Tray |
|
| |
| Carriage Bolt | Figure 23 |
|
|
26 |
