STARTING . . . .
Press the POWER button on the A3.2 amplifier - the red power LED on the front panel will light indicating that the unit is ready for use. However, for about five sec- onds no sound will be heard from your speakers, and the blue LED on the volume knob will not be lit, confirming initial mute action.
Unless using your amplifier for
monitoring (see paragraph opposite ) ensure that the TAPE MONITOR button has not been pressed accidently, as other- wise no sound will be heard through the speakers.
Select the required audio input source by pressing an appropriate function button on the front panel or remote control, and adjust the volume control to obtain the preferred sound level.
TAPE RECORDING
To record, simply select the required source with the input selector button on the front panel or remote control. This source will now be routed to the A3.2’s TAPE RECORD output for recording by the external tape deck. You will also be able to hear the selected source through the loud- speakers.
Note - adjustment of the volume control has no effect on the recording level.
OPERATION
OFF TAPE MONITORING
The A3.2 amplifier has a single tape circuit with facilities for
In conjunction with a
The MONITOR button on the front panel can now be used to switch between the orig- inal source sound and the recorded version, allowing direct comparison. The blue LED just above the monitor button is lit when the tape monitor function is operating, confirm- ing that the recorded sound is selected.
On some
If in doubt, please refer to your tape deck operating manual.
Issue 1: March 2002
A 3.2 Integrated Amplifier | Instructions for use Page 7 of 9 |
|
|