N-Tron 300 Series

Rev 100807

DIN-Rail Mounting

Install the unit in a standard DIN-Rail. Recess the unit to allow at least 5” of horizontal clearance for fiber

optic cable bend radius (2” for TX models).

To install the unit to 35mm industrial DIN-

Rail, place the top edge of the included mounting

bracket on the back of the unit against the DIN-

Rail at a 15° angle as shown. Rotate the bottom

of the unit to the back (away from you) until it

snaps into place.

To remove the unit from the 35mm industrial

DIN-Rail, place a flat head screwdriver into the

orange release clip found at the bottom of the

unit, and apply downward force on the clip until

it disengages from the bottom of the unit from the

DIN-Rail. Rotate the bottom of the unit towards

you and up at an approximate 15° upward angle

to completely remove the unit.

300-PM 900-PM

900-RM

With the except ion of the 524TX

and 526FX2, all N-Tron™ products

are designed to be mounted on

industry standard 35mm DIN-Rai l.

However, DIN-Rail mounting may

not be suitable for all applications.

We offer three alternative mounting

solutions: Our 300 Panel Mount

Assembly (P/N: 300-PM) may be

used to mount a single 300 Series unit

to a panel or other flat surface. Our

900 Panel Mount Assembly (P/ N:

900-PM) may be used to securely

mount our 100, 200, 300, 400, 500, or

900 Series products to a panel or

other flat surface; Our Rack Mount

Assembly (P/N: 900-RM) may b e

used to mount our pr oducts t o

standard 19" racks.