N-Tron 300 Series manual Connecting the Unit, Troubleshooting, Support FCC Statement

CONNECTING THE UNIT

For 300 Series fiber units, remove the dust cap from the fiber optic connectors and connect the fiber optic cables. For Fiber Optic ports, the TX port on the near station should be connected to the RX port of the far end station, and the RX port should be connected to the TX port of the far end station.

For 10Base-T ports, plug a Category 3 (or greater) twisted pair cable into the RJ45 connector. For 100Base-T ports, plug a Category 5 (or greater) twisted pair cable into the RJ45 connector. Connect the other end to the far end station. Verify that the LNK LED’s are ON once the connection has been completed. To connect any other port to another Switch or Repeater, use a standard Cat5 straight through or crossover cable.

TROUBLESHOOTING

1.Make sure the (Power LED) is ON.

2.Verify that Link LED’s are ON for connected ports.

3.Verify cabling used between stations.

4.Verify that cabling is Category 5 (or greater) for 100Mbit Operation.

5.Verify TX is connected to far end RX and vise versa (fiber optic units only).

SUPPORT

Contact N-TRON Corp. at: TEL: 251-342-2164 FAX: 251-342-6353 www.n-tron.com support@n-tron.com

FCC STATEMENT

This product complies with Part 15 of the FCC-A Rules.

Operation is subject to the following conditions:

(1)This device may not cause harmful Interference

(2)This device must accept any interference received, including interference that may cause undesired operation.

Rev 100807 13