NAD T775 owner manual Factory Reset, Delete Mode, operation, USING THE HTR 3 REMOTE CONTROL

Models: T775

1 44
Download 44 pages 3.53 Kb
Page 39
Image 39
Factory Reset

operation

USING THE HTR 3 REMOTE CONTROL

Factory Reset

The HTR 3 can be reset to its factory state, deleting all learned commands, copied and punched- through keys, macros, and other setup information, reverting all keys to their pre-programmed library commands.

To perform a factory reset simultaneously press-and-hold for 10 seconds the HTR 3’s [ON] and [RTN] keys; the Learn LED will start to flash green. Release [ON] and [RTN] before the second flash is complete; the Learn LED will turn red, indicating the remote has been reset.

Note

You must release [ON] and [RTN] before the second flash goes out, otherwise the unit will not reset; should this occur, repeat the full procedure.

Delete Mode

The HTR 3 can store learned, copied, and “default library” commands on any single key (The default library commands are the pre-programmed NAD codes, such as the native T 775 commands on the [AMP] “page.”).

You can delete commands by layers back “down” to the default library command on any key, removing learned commands, punched-through functions, and copied keys.

Note

The default library commands cannot be deleted, so you need not worry that using Delete Mode might cause irreparable changes.

To enter Delete Mode, simultaneously press-and-hold for 3 seconds both the desired key’s Device Selector key and the [RTN] key, until the Learn LED turns green. Press the function key whose command you wish to delete; the Learn LED flashes; the number of times indicates which type of function has become active - see the table below. Press the active Device Selector key again to exit Delete Mode.

Note

You may delete multiple function-key commands on the same Device Selector “page,” but to delete from more than one Device Selector page you must exit Delete Mode and then re-enter it on the required page.

Flashes

Command Type

1Default Library Command

2Copied Library Command

3Learned Command

ENGLISH

FRANÇAIS

ESPAÑOL

ITALIANO

SVENSKA NEDERLANDS DEUTSCH

РУССКИЙ

39

Page 39
Image 39
NAD T775 Factory Reset, Delete Mode, operation, USING THE HTR 3 REMOTE CONTROL, English Français Español Italiano