NAD T775 owner manual Front Panel, Navigation and Enter buttons These buttons are used to

ENGLISH

FRANÇAIS

ESPAÑOL

identification of controls

FRONT PANEL

1 2 3 4 5 6 7 8 9

10 11 12 13 14 15 16 17 18

ITALIANO

DEUTSCH NEDERLANDS SVENSKA

РУССКИЙ

1POWER BUTTON : Press this button or the HTR 3 remote’s [ON] button to switch ON the T 775. The Standby LED indicator will turn from amber to blue and illuminate the VFD. Pressing the power button again turns the unit back to standby mode.

The T 775 can also be switched ON from standby mode by pressing any of the front panel buttons. When both Main and Zones are ON, press and hold this button for more than five seconds to place them at standby mode.

Notes:

•The rear panel POWER switch must be in the ON position for the Power button to activate.

•If Auto Trigger IN at Trigger Setup menu is assigned to ‘Main’ or ‘All’ and the TRIGGER switch is set to ‘AUTO’ mode, the Power button in the front panel as well as the corresponding ON/OFF function keys in the HTR 3 remote control will be disabled effectively handing this function to an external controller. Switch TRIGGER to ‘OFF’ to maintain normal power ON/OFF function procedures. (See section also about “Trigger Setup” under the “Setup Menu” discussions.

2STANDBY LED : This indicator will light up amber when the T 775 is in standby state. When the T 775 main or zones are in the ON state, this indicator will illuminate blue. In the unlikely event that the T 775 switches to protection state, then this indicator will illuminate red. When infrared command from the HTR 3 is received, this indicator will also flash momentarily.

3INFO : Repeatedly toggle this button (press/hold first if in Tuner mode and then toggle) to display both at the Vacuum Fluorescent Display (VFD) and On-Screen Display (OSD) the following – Current Source, Volume level, Listening mode, Audio Source Format, and active Zones with their corresponding Source Inputs. While at Tuner mode, toggle this button to cycle through Preset Name, RDS name and RDS text.

4AM/FM/DB : Toggle this button to select either AM, FM, DAB (Europe version) or XM (North America version) tuner functions.

5TUNER MODE : In FM mode, this button will toggle between FM Stereo and FM mono. Select FM Mono (FM stereo and FM Mute icons at VFD are extinguished) for stations that have too much interference or are too weak. In DAB (Europe version) or XM (North America version) radio, this button enables the digital radio menu in conjunction with the Navigation button and Enter buttons.

6MEMORY : Press this button to store tuned AM, FM and digital radio stations to the T 775’s 40 preset-memory locations. One can store a mix of any AM, FM and digital radio stations to the 40 available presets.

7.NAVIGATION and ENTER buttons : These buttons are used to

navigate the T 775 OSD, Tune Scan Forwardand Tune Scan Reverse , Preset Skip Forward and Preset Skip Reverse as well as navigation of DAB (European version), XM (North American version) tuner functions and iPod.

8VACUUM FLUORESCENT DISPLAY (VFD) : Provides visual information on all of the T 775’s important modes, settings and function for both Main and Zone locations.

9VOLUME : Use this control to adjust the volume level of the main speakers. The default volume level is -20dB. The VOLUME knob is also used to increment / decrement other adjustable parameters like Tone Controls.

10A SPEAKERS B : Press either speaker A or B or both to select the set of speakers you wish to listen to. Speaker A is the main set of 7 multichannel and surround speakers. Speaker B is an auxiliary set for remote locations such as other rooms of your home. For Speaker B selection, all surround sound sources are downmixed to stereo. Combining Speaker A and Speaker B (SPEAKERS A + B) will also result to the source being downmixed to stereo.