WGT-15 INSTRUMENT BODYPACK TRANSMITTER
1.Snap open the BATTERY COMPARTMENT (30) and insert a fresh 9V BATTERY (31), observing the correct polarity. Close the compartment. The
2.Turn on the
3.The
(4) on the Encore I receiver should now be lit, indicating a received signal from the transmitter. Adjust the volume of the receiver as per the Audio Output Instrument Connections section of the above Encore I receiver instructions. For optimum performance, an INPUT LEVEL CONTROL (34) is provided on the top panel of the
The AF LEVEL LED DISPLAY (5) on the Encore I receiver will light up to 5 LEDs (4 green and 1 red) for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, turn down the instrument volume or adjust the INPUT LEVEL CONTROL (34) on the
(Note: Scratchy noises can sometimes occur when some electric guitars/basses with dirty pots or connections are used with any wireless system. For this reason, the supplied INSTRUMENT CORD (35) has a factory installed capacitor inside the 1/ 4" plug. This capacitor provides first order filtering of the RF signal from the cord into the guitar and eliminates virtually all scratchy noises. Should your equipment still give you scratchy noises, we suggest these steps to eliminate them:
1)Make sure all guitar volume and tone pots are clean and all contacts are solid – this is very important.
2)Provide extra filtering with a 220 pF capacitor soldered across the hot to ground terminals of the guitar's volume and tone pots.)
3235
34
33
32
30
30
Opening Battery Compartment
31
12 | 13 |