Nady Systems RPA-2 Rear Panel Control & Connections, Front Panel Controls & Connections

FRONT PANEL CONTROLS & CONNECTIONS

(13) (14) (15) (16)

(13) EFFECTS SEND

This line level output can be connected to external recorders, amplifiers, or effects processors. The signal is a mix of the channel inputs determined by each Channel Gain control.

(15) AUXILLIARY OUTPUT

This line level output can be connected to external recorders, mixers, or amplifiers.

(16) TAPE IN AND TAPE OUT

(14) EFFECTS RETURN

This input can be used to return the effected signal into the RPA-2 or it can be used as an auxiliary input. The input signal can be adjusted by the Master Volume and the unit the Return jack is connected to.

The Left and Right TAPE IN allows cassette recorders or CD players to be added to the Main output. The RECORD OUTPUT, with TAPE RCA jacks, provides signal output to a cassette deck or home audio equipment.

REAR PANEL CONTROL & CONNECTIONS

				(19) POWER CONNECTOR WITH FUSE HOLDER
				This standard IEC power cord receptacle is used to connect the
			(19)	AC power to your unit. It features a built-in fuse holder for a
				5X20mm, (2.5A/250V for 115VAC, and 1.5A/250V for 230VAC
				operation) fast-blow fuse. If the fuse continuously blows, shut off
				the unit and have it serviced by qualified service personnel.
				(20) EXTERNAL SPEAKER OUTPUT
(20)	(21)
				1/4" (6.3mm) jack for connecting an external speaker cabinet to
				the RPA-2. The connected speaker impedance must be 8 ohms
				or greater. The RPA-2 external speaker output delivers 25W RMS
				of power @ 8 Ohms.
				CAUTION: Do not overload the RPA-2 with speaker loads less
	(18)	(17)
				than 8 ohms as this will degrade performance and may harm the
REAR PANEL				unit. Damage caused by improper use is not covered by the
				warranty.

(17) POWER SWITCH

Turns the unit ON or OFF. Always turn level controls down before	(21) LINE OUTPUT
	This 1/4" (6.3mm) audio output is line level, post Master Volume,
turning on the unit.
	designed for connecting to external recorders, mixers, or amplifi-
(18) VOLTAGE SELECTOR SWITCH	ers.
For selecting the proper voltage (115/230VAC) to match the power
supply in your area.

Note: To avoid damage to your unit, always make sure this switch is set to the correct supply voltage. Damage caused by improper use is not covered by the warranty.

6