Napco Security Technologies GEM-RP3DGTL manual Yes

KEYPAD FUNCTIONS

09

INTERIOR BYPASS FIRE/TBL SYS TBL CHIME

10

INTERIOR BYPASS FIRE/TBL SYS TBL CHIME

11

INTERIOR BYPASS FIRE/TBL SYS TBL CHIME

12

INTERIOR BYPASS FIRE/TBL SYS TBL CHIME

13

INTERIOR BYPASS FIRE/TBL SYS TBL CHIME

18

9.Reset System Trouble? System troubles display and sound at the keypad. Correcting the trouble will clear most indications, however the following error codes will require manual reset: E11; E13; E19; E20 and E22. (See SYSTEM TROUBLE ERROR CODES for a description of error codes.)

10.For installer's use only. If accidentally enabled, press theCbutton to exit.

11. Start Exit Time? (Start Exit Time programmed? YES NO.)

In Commercial Burglary systems, exit delay may have been programmed to start after a central-station “ringback” (verification) signal has been received. If the ringback tone has not been received within about 30 seconds after arming, a communication problem may exist. Use this function to start exit delay manually, then exit the premises immediately. Be sure to have your alarm specialist check communications with the central station as soon as possible.

12.Activate Fault Find? For installer's use only. If accidentally enabled, press the C button to exit.

13.Activate Locate? For installer's use only. If accidentally enabled, press the C button to exit.

GEM-RP3DGTL.pub	Wednesday, August 18, 1999 14:03
page 18