Napco Security Technologies GEM-RP3DGTL manual Programming Optional, Programming Example

PROGRAMMING (OPTIONAL)

6.Continuing, set the cursor to the user code with the A button and enter

the new User Code using the number but- tons. Press G0 for any blank loca- tions until you end up back to the flashing “UP”.

7. Press the Jbutton to save the code

in memory.

Repeat Steps 4 through 7 for each user.

Note: To void a code, simply enter the 2-digit user number, then press the Jbut-

ton.

Programming Example

Example. Program User 3's Code as “3784”.

1.Select the Program Mode as follows:

(a) Enter your code, then press the

Abutton.

To Program User Codes

1. Enter program code, then press the A button.

2. Press NO (F) until “17”

displays, then press YES (E).

3. When “UP” displays with a flashing light, use the number buttons to enter a 2-digit user number followed by a user code of up to 6 digits.

4. Press the Jbutton to save.

5. Repeat steps 3 & 4 to enter all user codes.

6. Press the C button to exit.

NOTE: Press G0button to clear character at cursor.

To continue press E or F button.

Programming User Codes

(b) Answer NO (F button) repeatedly until “17” is displayed, then press the YESE( button). The display will scroll “P” followed by 4 digits (for installer's use), then “UP” (indicating user programming) and the lights will continue to flash.

2.Press the A button then 03 to enter User No. 3, then press the A button again followed by 3784G0G0 to program the code.

25

GEM-RP3DGTL.pub	Wednesday, August 18, 1999 14:03
page 25