Disarming Your System / Silencing an Alarm
Disarming Your System when Returning
1
2
Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to dis- arm the system before your Entry Delay time expires.
Enter your user code. The Red W Armed light will go out, indicating that the system has been disarmed. Note: If you make a mistake entering your code, press the Bkey and
Alarm Indication
If the Red WArmed light is flashing rapidly, an alarm occurred while you were away. Proceed with caution! For your own protection, leave immediately and call authorities from a neighbor’s phone .
Silencing an Alarm
In the event that the system goes into alarm due to a violated burglary zone, the bell or siren will sound and the keypad sounder will also activate. To silence the system, enter your User code. The zone light of the zone which went into alarm will continue to flash until Bis pressed to reset the alarm memory.
Silencing a Fire Alarm
In the event that the Fire alarm activates due to an violated smoke or fire detector, the bell or siren will sound a distinct pulsating tone. The Red I FIRE light on the keypad will be flashing, and the keypad sounder will emit
a pulsing tone. If a Fire Alarm does occur:
1If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone.
2If there is no evidence of a fire, enter your User Code. The bell or siren will silence, and the IFIRE light on the keypad will stop flashing but will still be lit.
3 Determine which device went into alarm. If you are protected by smoke detectors, the light on the active detector will be lit. Once it is determined which smoke detector is in alarm, press Bto reset the fire zone.
4If the Fire zone has reset properly, the FIRE light on the keypad should go out in approx. 30 seconds If it does not go out, press Bagain in a few minutes. If the FIRE light still does not go out, call for service.
8
