LOG PLACEMENT
PHAZERTM logs, glowing and charcoal embers, exclusive to Napoleon fireplaces, provide a unique and realistic glow- ing effect that is different in every installation. Take the time to carefully position the embers for a maximum glowing effect. Figures 27 A - H.
A | LOCATING PINS | #1 | LOCATING PINS |
| PILOT |
|
|
15
E |
#3
5.When pieces #3a and #3b are attached to create log #3, the upper end of log #3 should rest in the groove, on top of log # 2.
F |
1. Looking at the unit from the valve side, place log #1 diagonally across the textured burner cover onto the pins. The texture is designed to cradle the underside of the log.
B | #2 |
#4
6.As with log # 1, log #4 is also cradled by the texture of the burner cover and the pin in the base. Position log #4 so that the lower end fits onto the pin. The upper end rests against the moulded locater on the top of log # 1.
2.Depending on the type of installation, the view of the log positioning will reverse. Here the lower end of log #2 rests near the back left corner of the firebox on the locating pin. The upper end sits on top of log #1, inside the groove on log #2.
G | #5 | |
b | ||
| ||
| a |
7. Like log #3, log #5 |
also comes in two |
pieces. The base |
(#5a) slopes out- |
wards between logs |
#2 and #4. |
As with pieces #3a & |
b, piece #5b fits over |
piece #5a. Place the |
end of piece #5b onto |
the pin. |
C |
D |
#3a
#3
b
a
3.Log # 3 is made up of two pieces, a and b. Piece #3a is the base of log #3. The base sits diagonally in the designated area lo- cated between logs #1 and fits tight up against #2.
4.The slot in the under- side of piece #3b fits over #3a. Place the end of piece #3b onto the pin.
H | #2 |
#5
#3 | #1 | #4 |
8.The upper end of log #5 rests in the groove, on top of log #4 and creates the final appearance of log set.
