13
GAS INSTALLATION
Proceed once the vent installation is complete.
1.Move the fireplace into position and secure using the nailing tabs and/or secure to the floor through the 1/4"ø holes located at either end of the base.
2.Route a 3/8" N.P.T. black iron gas line, 1/2"
3.For ease of accessibility, an optional remote wall switch or millivolt thermostat may be installed in a convenient lo- cation. Route
WIRE SIZE | MAX. LENGTH |
14gauge | 100 feet |
16gauge | 60 feet |
18gauge | 40 feet |
Attach the one lead to terminal 3 (located on the gas valve) and the other lead to the vent safety switch wire ( located loose in the valve compartment). See FIGURE 3.
Do not connect either the wall switch, thermostat or gas valve to electricity (110 volts).
FIGURE21 | 1 |
|
|
|
|
2 |
| OL |
|
| |
|
| O | F | ||
|
|
|
| N | O |
|
|
| HI | F | |
|
|
|
| IP | |
|
|
|
|
| |
|
| 3 |
|
| TOL |
|
| P |
|
| |
|
|
| TOLI |
|
|
4.Install rigid black pipe, 1/2"
FLEXIBLE CONNECTOR. FIGURE 6.
5.Check for gas leaks by brushing on a soap and water solution. Do not use open flame.
FIGURE22
6.Mark the appropriate boxes on the rating plate label to indicate the model type.
Purge all gas lines with the glass door of the fire- place open. Assure that a continuous gas flow is