16
GLOWING EMBERS
L36 LOUVRE INSTALLATION
For proper ignition, it is very important to that glowing embers are in place. Tear the embers into small pieces and place on the ported area of the burner. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports. Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame.
CHARCOAL EMBERS
Randomly place the embers around the bottom brick pan- els in a realistic manner but not in contact with the flames. Keep ember dust away from burner ports to avoid plugging them.
Fine dust found in bottom of bag not to be used. PHAZERTM logs, and embers glow when exposed to direct flame. Use only certified PHAZERTM logs, glowing embers and char- coal embers available from your Napoleon / Wolf Steel Ltd.
dealer.FIGURE28
GLOWING EMBERS
Ensure that glowing embers sufficiently cover the carry over ports, highlighted below, to achieve maximum glow.
CARRY OVER PORTS
FIGURE36a-c
B
C
A CLIPS
FLANGE
C E N T R E
SLOT
SLOT
TA B
B
A
HOOD
Attach the hood by pressing the top flange into the clips along the top of the louvre opening. Secure using a screw through the centre slot.
UPPER LOUVRES
Insert the louvre tabs into the slots located at the top left and right corners of the unit.
FIGURE29
LOGO PLACEMENT
C
HINGE
CLIP
SLOT
LOWER LOUVRES
Insert the hinge clips into the slots located at the bottom left and right corners of the unit.
To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assem- bly back. Lift the clip.
Remove the backing of the logo supplied and place on the glass viewing door, as indicated.
½" |
LOGO |
½" |
FIGURE30 |