24
LOG PLACEMENTPHAZERTM logs and glowing embers exclusive to Napoleon Fire- places, provide a unique and realistic glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log colours may vary. During the initial use of the fireplace, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
FIGURE#1
1.Place the back log (#1) onto the log support tray and in front of the tabs. The tabs maintain an air space between the log and firebox back to facilitate combustion air flow. Ensure that the back of the log rests against the brackets on the back wall of the firebox.
#2 #3
2.Move the two small logs (#2 & #3) into position, lining up the studs located on the burner with the holes on the bottom of the logs. Ensure that the small logs sit flat on the burner.
#4
3.Place the bottom of the left crossover log (#4) against the left firebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.#5
4.Position the notch located on the end of the center log (#5) against the middle grate post with the other end of the log resting in the pocket of the left crossover log.
#6
5.Place the bottom of the right crossover log (#6) against the right firebox side and pulled forward to the grate. The top of the log should rest in the pocket provided on the center log (#5).
CHARCOAL EMBERSRandomly place the charcoal embers along the front and sides of the log support tray in a realistic manner. Fine dust found in the bottom of the bag should not be used.
VERMICULITE (MODEL GD36 ONLY)Sprinkle vermiculite around the charcoal embers.Note: Both charcoal embers and vermiculite are not to be placed on the burner.GLOWING EMBERSTear the embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame. Use only certified "glowing embers" and PHAZERTM logs available from your Napoleon dealer.
LOGO PLACEMENT| Remove the backing of the | ½" |
|
|
| |||
| logo supplied and place on the |
|
|
| ||||
|
|
|
|
|
| ||
| glass viewing door, as |
|
|
|
|
|
| |
|
|
| LOGO |
|
| ||
| indicated. |
|
|
|
| |||
|
|
|
|
|
| ||
½" | |||||||
| |||||||
| FIGURE 47 | ||||||