8
LOG PLACEMENT INSTRUCTIONS
Blocked burner ports can cause an incorrect flame pat- tern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct flame and provide a unique and realistic glowing effect. Use only certified PHAZERTM logs available from your Napoleon / Wolf Steel Ltd. dealer.
1 | FIGURES |
#1
The notch in log #5 should be pressed down onto the skewering pin located at the end of the grate as shown to prevent it from rocking.
3 |
#6
#4#3 #2
Place log #1 onto the burner, centering it onto the burner tray and pushing it as close to the rear wall of the firebox as possible. Move logs # 2 and 3 into position, lining up the studs located on the burner with the holes on the bot- tom of the logs. Sit the notch at the bottom of log #4 against the left outermost grate post and position the top of the log into the pocket provided on the rear log (#1).
2 |
#5
Position the notch located in log #6 against the grate post.
4 |
#7
Place the bottom of log #7 against the right outermost grate post and the top into the pocket provided on the center log (#6). Tear the glowing embers into pieces and place onto the front of the burner. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow when exposed to direct flame; however care should be taken to not block the burner ports. Blocked ports can cause an incorrect flame pattern, carbon deposits and delayed ignition.
Log colours may vary. During the initial use of the fire- place, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
