20
NZ64 BLOWER INSTALLATION
This unit is supplied with a pressure switch and a thermally activated switch. Ensure that the pressure switch actuating arm protrudes through the faceplate when installed.
The blower will only operate when the doors are fully closed.
1.Remove the template.
2.Position the blower to an in-
side or outside wall into a framed open-
ing 12 3/8” wide by 10 1/2” high. (Outside wall
not recommended in colder climates as cold air may be drawn into the house when the fireplace is off.)
The blower housing should be installed onto a level surface large enough to support the blower assembly.
Allow for finishing material when securing the blower housing, as the grill mounts to the hous- ing.
3.Connect the 6” collar to the blower opening located on the side of the unit. An optional opening is covered on the other side of the unit. If this location is preferred, switch the cover plate and collar.
Secure by reaching through the collar and bending the tabs.
Use sealant to ensure that the connection is air tight.
We recommend installing the blower in a different room or even different level of the house. This will generate greater air movement and improve the distribution of the warm air coming from the fireplace.
