Napoleon Grills PTSS450RSB GAS HOOK-UP INSTRUCTIONS, LEAK TESTING INSTRUCTIONS

LEAK TESTING: This must be done before initial use, annually and whenever any gas components are replaced or

serviced. No smoking while performing this test, and remove all sources of ignition. See

for areas to

check.

1. Turnall burner controls to off. Turn supply valve on.

2. Brush a half and half solution of liquid soap and water onto all joints and connections of the regulator,hose, manifolds

and valves.

3. Bubbles will indicate a gas leak. Either tighten the loose joint or replace the part with one recommended by the dealer.

4. If the leak cannot be stopped, shut off the gas supply,disconnect it and have the barbecue inspected by your gas

supplier or dealer.Do not use the appliance until the leak has been corrected.

5. Turn offgas supply.

GAS HOOK-UP INSTRUCTIONS

CYLINDER CONNECTION: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylinder fuel

valve. Insert the black QCC1 regulator nipple onto the QCC1 fuel valve. Hand tighten clockwise.

Aleak test must be performed annually, and each time a cylinder is hooked up, or if a part of the

gas system is replaced.

PROPANECYLINDER INSTALLATION: Set cylinder into hole in bottom shelf.

IMPORTANT: The regulator must be attached so that no part of the hose touches the underside of the grill or drippan.

A fire will result if these directions are ignored.

NATURALGAS HOOK-UP: This natural gas grill is supplied with a 10ft supply hose (complete with a quick disconnect) designed

for natural gas and certified for outdoor use. Thegas grill is designed to operate at an inlet pressure of 7 inches water column. Piping

and valves upstream of the quick disconnect are not supplied.

The quick disconnect must not be installedin an upward direction and a readily accessible manual shut-off valve must be installed

upstream of, and as close to, the quick disconnect as is feasible. Theflared end of the hose must be connected to the unit as

illustrated in the

diagram. These connections must be made by a licensed gas installer. Leak test all

joints prior to using the gas grill.

MODEL SS450RSB: Connect the 20" hose from the manifold, to the side burner as illustrated in the

diagram. Connectthe supply hose to the flare connection which faces down from the side burner. Tighten all connections

using two wrenches. (

LEAK TESTING INSTRUCTIONS