National Instruments FP-PS-4 LN

©NationalInstruments Corp. 7 FP-PS-4Operating Instructions

Ensurethat all the wiring is installed according to local codes and

regulationsby qualified electrical personnel. Follow these steps to

connectthe FP-PS-4 to your FieldPoint system.

1. Usea 16 to 26 AWG stranded wire to connect the FP-PS-4 to

yourFieldPoint network module or I/O module. Connect the

positivewire to the V terminal and the negative wire to the

Cterminal of the FP-PS-4.

2. Connectthe other ends of the wires to the V and C terminals of

theFieldPoint network module or I/O module.

3. Ensurethat the plug-in AC input terminal connector is plugged

intothe input port on the FP-PS-4.

Note Becareful to install the correct conductor in t he

appropriateterminal. The color of the conductorwires

variesdepending on North American versus international

standardsas described in Figure 7. The wires are drawn

toscale according to the 7 mm(0.275 in.) strip length

requirement.

Figure7. Conductor Wire Color Standards for the Plug-in AC Input

TerminalConnector

4. Connectthe black or brown conductor into the line terminal

labeledL.

5. Connectthe white or blue conductor into the neutral terminal

labeledN.

1 Line wire (black by North American standards; brown by international

standards)

2 Neutral wire (white by North American standards; blue by international

standards)

3 Ground wire (green by North American standards; green/yellow by

internationalstandards)

4 Plug-in AC input terminal connector