Chapter 1 Introduction
NI CardBus-8310-to-PXI Expansion User Manual 1-2 ni.com
Figure1-1 shows the basic architecture of an NI CardBus-8310-to-P XI
system. The NI CardBus-8310 consists of a CardBus connector, a
CardBus-to-PXI bridge, a StarFabric bridge and two RJ-45 connectors. The
NI PXI-8310 consists of two RJ-45 connectors, a StarFabric bridge, and a
PXI connector.
Figure 1-1. NI CardBus-8310-to-PXI Block Diagram
Functional Unit Descriptions
This section describes the individual units that comprise an
NICardBus-831 0-to-PXI system.
CardBus Connector
The CardBus connector allows the NI CardBus-8310 to be used in a laptop
CardBus expansion slot. This connector is defined by the PCMCIA
Specification.
StarFabric Bridge
A PCI-to-StarFabric bridge provides an interface between PCI and
StarFabric by translating PCI traffic into serial frame format for
transmission across StarFabric. The PCI bus is a 32-bit parallel bus that
transfers data between a master and a slave at 33 MHz, while the StarFabric
link can simultaneously transmit and receive at 2.5 Gbps. A standard link
is made up of four aggregated 622 Mbps LVDS differential pairs in each
direction.
RJ-45
Connector
RJ-45
Connector
Starfabric
Bridge
Starfabric
Bridge
RJ-45
Connector
RJ-45
Connector
Cardbus-8310 PXI-8310
Cardbus
PXI Bus