Chapter 2 Installation and Configuration
NI PXIe-8130 User Manual 2-2 ni.com
4. Remove the protective plastic covers from the four bracket-retaining
screws as shown in Figure2-1.
Figure 2-1. Removing Protective Screw Caps
5. Make sure the injector/ejector handle is in its downward position.
Align the NI PXIe-8130 with the card guides on the top and bottom
oft he system controller slot.
Caution Do not raise the injector/ejector handle as you insert the NI PXIe-8130.
Them odule will not insert properly unless the handle is in its downward position
so that itd oes not interfere with the injector rail on the chassis.
6. Hold the handle as you slowly slide the module into the chassis until
the handle catches on the injector/ejector rail.
7. Raise the injector/ejector handle until the module firmly seats
into the backplane receptacle connectors. The front panel of the
NIPXIe-81 30 should be even with the front panel of the chassis.
1Protective Screw Cap (4X)
1