National Instruments NI PXIe-8130 - page 66

Chapter 5 Troubleshooting
© National Instruments Corporation 5-3 NI PXIe-8130 User Manual
3. Move the jumper on W2 from pins 1–2 to pins 2–3 as shown in
Figure 5-1.
4. Wait one second. Move the jumper back to pins 1–2.
5. Reinstall the controller in the chassis.
Caution Do not leave the jumper on pins 2–3. Doing so decreases battery life. Also, the
controller will not boot.
Figure 5-1. Clearing the CMOS Contents
1Clear CMOS Contents2Pin 1 3Normal Operation (Default)
1
3
2