Troubleshooting

No Picture

• The display card should be completely seated in itsslot.
• Power Switch and computer power switch should be in the ON position.
• The signal cable should be completely connected to the display
card/computer.
• Check the connector for bent or pushed-in pins.

Image is scrolling or unstable

• Signal cable should be completely attached to the computer.
• Check the pin assignment and signal timing of your monitor and
display card with respect to the recommendedtiming and pin
assignment.
• If the MAC adapter is used, check for proper connectionor make sure
the display card is MAC compatible and that the cardis properly seated
in the computer.
LED on monitor is not lit (no green, orange or yellowcolor can be seen)
• Power Switch should be in the ON position and the power cord should
be connected.

Picture is fuzzy or color looks blotchy

• Adjust the Brightness and Contrast Controls.
• Access the Degauss Control through OSM. Activate the Degauss
Control.
CAUTION: A minimum interval of 20 minutes should exist before the
Degauss Function is used a second time.

Picture bounces or a waving pattern is present in the

picture

• Move electrical devices that may be causing electrical interference away
from the monitor.

Edges of the display image are not square

• Use the OSM Geometry Controls to straighten the edges.
• If possible, position the front of the monitor facing east.

Display image is not centered, too smaIl, or too large

• Use the OSM Size and Position controls to adjust the image.

E - 13

0
5
25
75
95
100
ENGLISH.CHP
Sun Oct 11 19:37:41 1998
Farbprofil: Deaktiviert
Komposit Standardbildschirm