Quick Start

To attach the MultiSync A Series monitor to your system,

follow these instructions:

1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information, refer to the
display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of thecaptive signal cable
to the connector of the display card in your system (Figure A.1).
Tighten all screws.
For the Mac: Connect the MultiSync A500+ or MultiSync A700+
Macintosh Cable Adapter (not included) to the monitor connector on
the Macintosh (Figure B.1). Attach the 15-pin mini D-SUB end of the
captive signal cable to the Macintosh cable adapteron the computer
(Figure B.1). Tighten all screws.
4. Connect one end of the power cord to the MultiSync A Series monitor
and the other end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
6. This completes the installation.
NOTE: If you have any problems, please refer to the Troubleshooting
section of this User's Manual.
Figure A.1
Captive Signal Cable
15-pin mini D-SUB

E-2

0
5
25
75
95
100
ENGLISH.CHP
Sun Oct 11 19:37:12 1998
Farbprofil: Deaktiviert
Komposit Standardbildschirm