NEC FP1375X user manual Information, English-11

NOTE: For standard systems and graphics boards, keep the factory setting at ENABLE.

EdgeLock Control: Operating your monitor at a non-standard timing may cause images to appear darker than normal or have colour distortion. Use of the EdgeLock control will adjust images to their normal state.

Video Detect: Selects the method of video detection when more than one computer is connected.

NONE: The monitor will not search the other video input port unless the monitor is turned on.

FIRST DETECT: The video input has to be switched to “FIRST DETECT” mode. When current video input signal is not present, then the monitor searches for a video signal from the other video signal input port. If the video signal is present in the other port, then the monitor switches the video source input port to the new found video source automatically. The monitor will not look for other video signals while the current video source is present.

LAST DETECT: The video input has to be switched to the “LAST DETECT” mode. When the monitor is displaying a signal from the D-Sub and a new secondary source is supplied to DVI-Analog or Digital, then the monitor will automatocally switch to the new video source. When current video input signal is not present, then the monitor searches for a video signal from the other video input port.

DVI Selection: This function selects the DVI input mode. When the DVI selection has been changed, you must restart your computer.

DIGITAL: DVI digital input is available.

ANALOG: DVI analog input is available.

Information

Display Mode: Indicates the current mode and frequency setting of the monitor.

Monitor Info: Indicates the model and serial numbers of your monitor.

Refresh Notifier: A message will advise you if the refresh rate of the signal being applied to the monitor by the computer is too low. For further information, please refer to your display card or system manual.

English-11

English