AC Power Cord

Always use the power supply cord that is enclosed with

the unit.

If the enclosed power supply cord is not used, use a power cord that conforms to the following regional standards.

U.S.A

UL

Switzerland

SEV

Canada

CSA

Britain

BASEC / BS

Germany

VDE

 

 

In other regions, for safety please use an AC plug cord that complies with each country’s safety regulations.

Power Cord Connection

Always use the accessory power cord and be sure to

connect the ground line.

1Use the accessory AC power cord.

2Connect the AC plug (female pins) to the main unit.

3Connect the AC plug (male pins) to the electrical outlet. Caution: Always connect the ground wire.

4Attach the cord compartment cover.

 

4

3

2

 

 

1

Turn on the Power

Figure 2

Figure 1

Place the monitor where it will be used.

Use a power source that supplies AC 100 V - 240 V at 50 Hz / 60 Hz. Turn on the power switch of the display panel (Figure 1: Press the switch continuously until the pilot LED lights.) and then turn on the computer power switch (Figure 2).

** Refer to the section “Operation Procedures” on page I-12. Use the desired setting.

I - 10

Page 11
Image 11
NEC LA-1524HMW manual AC Power Cord, Turn on the Power