NEC LCD1510+ user manual Quick Start

Quick Start

To attach your MultiSync® LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable

to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the Mac: Connect the MultiSync Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB end of the appropriate signal cable to the MultiSync Macintosh cable adapter (Figure B.1). Tighten all screws.

NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC Technologies at (800) 820-1230.

3.Connect the 15-pin mini DÊ SUB of the video signal cable and the AC Adapter cable. Place the AC Adapter cable under Clip A (Figure C.1).

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the module’s life.

4.Connect one end of the power cord to the AC Adapter and the other end to the power outlet (Figure D.1).

5.Turn on the monitor (Figure E.1) and the computer.

6.To complete the setup of your MultiSync LCD monitor: A. Set the resolution to 1024 x768 @ 75 Hz.

NOTE: For download information on the Windows® 95/98 INF file for your MultiSync LCD monitor, refer to the References section of this User’s Manual.

B. Use the following OSM™ controls:

• Auto Adjust Contrast

• Auto Adjust

NOTE: Manual adjustment of the H/V Position and Image Adjust H. Size/Fine controls may be required to complete setup of your MultiSync monitor. For a full description of these OSM controls, refer to the Controls section of this User’s Manual.

7.Refer to User’s Manual in the Pivot® Software CD case for installation and operation of this software.

NOTE: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

3

78134702.wpc 5 8/20/99, 10:46 AM