Quick Start cont.
Cable Management
To use the cable management feature, lift up then remove back cover (Figure CM.1). Place all cables into the vertical groove, leaving 6” of slack in the cables to allow the monitor to rotate between Landscape and Portrait orientation (Figure CM.2). To replace back cover, push in then slide down (Figure CM.3).
Cable Cover |
| |
Lift up then |
| |
remove | Leave sufficient | |
back cover | ||
length of cable | ||
| ||
| Push in and | |
| slide down |
Figure CM.1 | Figure CM.2 | Figure CM.3 |
Raise and Lower
Monitor Screen
The monitor may be raised or lowered in either Portrait or Landscape mode. To raise or lower screen, place one hand under bottom of screen (Figure RL.1), lift or lower slightly and simultaneously push the button on the bottom back of the stand (Figure RL.2). Screen will lower while button is pushed in. Release button to lock screen in place.
CAUTION: Although the monitor has been designed not to lower automatically when the button is pushed, ALWAYS support the bottom of the screen with one hand.
Figure RL.1 | Figure RL.2 |
5
78134702.wpc | 7 | 8/20/99, 10:46 AM |