Using the LCD with a Personal Computer –continued
3)Control sequence
(1)The command from a personal computer to the LCD monitor will be sent in 400ms.
(2)The LCD monitor will send a return command 400ms* after it has received an encode. If the command isn't received correctly, the LCD monitor will not send the return command.
(3)The personal computer checks the command and confirms if the command which has been sent has been executed or not.
(4)This LCD monitor sends various codes other than return code. When having a control sequence by
*: The sending time of return command may delay depending on the condition (during changing of the input signal, etc.).
[Example] Turn the power ON ( ' ' is for ASCII code)
Sending commands | Status code from LCD | Meaning | |
from the PC etc. | monitor | ||
| |||
30 30 21 0D |
| Command for POWER ON | |
'0' '0' '!' ' ' |
| ||
|
| ||
| 30 30 21 0D | Command received | |
| '0' '0' '!' ' ' | (Command echo back) |
4) Operation commands
The operation commands execute the basic operation setting of this LCD monitor.
It may not operate when changing the signal:
Operation | ASCII | HEX |
POWER ON | ! | 21h |
POWER OFF | " | 22h |
INPUT RGB 1 | _r1 | 5Fh 72h 31h |
INPUT RGB 2 | _r2 | 5Fh 72h 32h |
INPUT RGB 3 | _r3 | 5Fh 72h 33h |
INPUT VIDEO | _v1 | 5Fh 76h 31h |
INPUT DVD/HD | _v2 | 5Fh 76h 32h |
•POWER OFF command should be operated over1 minute after the power is turned on.
•POWER ON command should be operated over 1 minute after the power is turned off.
NOTE: For complete information please see file “External_Control_LCD4000e.pdf” on the