(English)
Configuration
The Switch Module can be configured locally using the Serial Port or remotely using the Ethernet ports.
Connection via Serial Port
Use a serial cable (with a female
Baud rate | 9600 |
Data bits | 8 |
Parity | None |
Stop bits | 1 |
Flow control | None |
IMPORTANT: A leased line cannot be connected to the Serial Port directly.
NOTES:
・The command line interface has 2 modes, AOS CLI and ISCLI. You can set the Switch Module to use either CLI mode. By default, the mode is AOS CLI.
・When operating the Switch Module with NEC WebSAM NetvisorPRO, use ISCLI.
Connection via Network
To connect to this Switch Module via network, you need to assign an IP address to it. You can access the
IP address is configured by the following.
-Assignment by DHCP (by default)
-Manual assignment
-Assignment by DHCP
By default, the management network interface on the Switch Module is set up to obtain its IP address from the DHCP server on the Enclosure Manager Card. You can configure the IP address in the Enclosure Manager Card. For more information, see the Enclosure Manager Card User’s Guide.
NOTES:
・If the IP address cannot be obtained from the DHCP server, access the local console of the Switch Module and assign the IP address manually. Refer to “Manual assignment” below. After assigning the IP address, then access the Switch Module via network.
・Port 19 of the Switch Module is connected with the management network in the Blade Enclosure.
・Refer to the Blade Enclosure User’s Guide and the Enclosure Manager Card User’s Guide about how to connect or configure the Enclosure Management LAN port.
34
